Filter
Top Products
87
PRIMERGY RX300 S2 User’s Guide
3
OS Installation Using ServerStart
3.4 Remote Installation
ServerStart supports remote installation.
Before performing remote installation, be sure to read "Cautions for Remote Installation" in the online
help.
3.4.1 Overview of Remote Installation
Remote installation is a method to save resources necessary for installation, such as the OS and Service
Pack, in a different server on the network and install them via the network.
If a remote resource server is configured, you can install the same resources to multiple servers. This
method is useful in configuring multiple servers.
● Target Server and Remote Resource Server/PXE Server
A server to which resources are installed is called a "target server". A server that stores resources
necessary for remote installation is called a "remote resource server". A server that can start up a target
server through network startup (PXE) is called a "PXE server".
■ Installation Method
Remote installation uses a PXE or a remote resource server.
● Remote Installation Using a PXE Server
In remote installation using a PXE server, the network startup (PXE) function of the PXE server starts
up the target server and performs installation in preconfiguration mode. This method is used when the
target server does not have a CD-ROM or floppy disk drive.
In addition to the PXE server, a "remote resource server" that stores remote resources and a "DHCP
server" that performs the DHCP service are required for remote installation using a PXE server. When
you have only one server, store remote resources on the PXE server to install the DHCP service. When
you have multiple servers, select one for performing the DHCP service and another for storing remote
resources.
Installation
using ServerStart
PXE server
Target server
Activated by IP address/
boot image
1)
Request resources2)
3) Supply resources
- OS
- Service Pack
- Application
etc.