Primera Technology RX300 S2 Server User Manual


 
36
Chapter1 Overview
1.4.5 Inserting and Ejecting a CD-ROM
This section explains how to insert and eject a CD-ROM.
Cautions for Handling CD-ROM Drive
Use the drive in a dry place with low airborne dust levels. Entry of water, a paper clip, or other liquids
or metal objects can cause electric shock or failures.
Do not use the drive in a place exposed to shocks or vibration.
Do not insert any object other than the specified CD-ROMs.
Do not pull or push the CD-ROM tray forcibly.
Do not disassemble the CD-ROM drive.
Clean the CD-ROM tray before use. Use a dry, soft cloth for cleaning.
When the CD-ROM drive is not used for a prolonged period, eject the CD-ROM to prevent accidents.
To avoid dust or particles, keep the CD-ROM tray closed (in a loaded position).
This server supports CD-ROMs with the following logo. Do not use CD-ROMs without the logo.
Doing so may cause failures.
Cautions for Handling CD-ROMs
When removing the disk from the case, pull the disk up while pressing the center holder of the case as
shown in the figure below.
Hold the CR-ROM on its edge to avoid contact with the disk surface.
Do not contaminate the CD-ROM surface with fingerprints, oil, or dust. If the disk is dirty, wipe it
from the center to the edge with a dry, soft cloth. Do not use benzine, thinner, water, record sprays,
antistatics, or silicone clothes.
Be careful not to scratch the CD-ROM surface.
Avoid heat.
Do not bend the floppy disk or place heavy objects on it.
Do not use a ball-point pen or pencil on the label (printed) side.
Do not apply stickers to the label side. Abnormal vibration can occur due to eccentricity.
When the CD-ROM is moved from a cold place into a warm place, dew condensation may occur,
resulting in data read errors. If this is the case, wipe droplets away with a dry, soft cloth and let the
unit dry naturally. Do not use a hair dryer.
To avoid dust, scratches, or deformation, store CD-ROMs in the case whenever not in use.
Do not store CD-ROMs in areas of high temperature exposed to direct sunlight for many hours or
near heating appliances.