Filter
Top Products
66 Printing Guide — Installing Client Software for Windows
9. The installation is completed.
NOTE: • Before using the printer driver for printing, please configure the installed options of
the equipment and department code (if required) on the printer driver.
P.204 "Before Using the Printer Driver"
Installing the Client Software for LPR Printing
This section describes how to set up the printer drivers for LPR printing which is available for
the local area network over TCP/IP.
There are Two ways to set up the printer drivers for LPR printing:
• Using the installer in the Client1 CD-ROM
You can set up the printer drivers for LPR printing by installing the printer drivers using the
installer in the Client1 CD-ROM. Then you install and configure the LPR port to configure
the connection.
P.66 "Installation for LPR Printing Using the Installer"
• Using Add Printer Wizard
When you want to install the printer drivers without using the installer, or when you want to
install the same printer driver for another equipment, install the printer drivers using the Add
Printer Wizard.
P.74 "Installation for LPR Printing by Add Printer Wizard"
PREPARATION:
• Before operating the following setup, check with your system administrator to make
sure of the following:
- This equipment is connected to the network and turned on.
- The TCP/IP setting is correct on this equipment and your computer.
NOTES:
• LPR Printing is only available for Windows NT 4.0, Windows 2000, Windows XP,
and Windows Server 2003.
Installation for LPR Printing Using the Installer
Install the client software using the installer in the Client1 CD-ROM first, then configure the
LPR port in each printer driver.
The procedure to configure the LPR port differs depending on the version of Windows used.
P.66 "Windows NT 4.0"
P.69 "Windows 2000/XP/Server 2003"
REQUIREMENT: • You must log into Windows as a user who has the “Administrators” or “Power Users”
privilege when using Windows NT 4.0, Windows 2000, Windows XP, or Windows
Server 2003.
— Windows NT 4.0
Configuring the LPR port for Windows NT 4.0
1. Install the client software using the installer in the Client1
CD-ROM.