Filter
Top Products
Appendix H EC/KBC Rewrite Procedures
Satellite Pro M10 Series Maintenance Manual (960-431) H-1
Appendix H
Appendix H EC/KBC Rewrite Procedures
This Appendix explains how to rewrite the EC/KBC system program when you update the
EC/KBC system.
Tools
To rewrite the EC/KBC, you need the following tool:
BIOS/EC/KBC rewriting disk for the computer
Rewriting the EC/KBC
NOTE: 1. Rewrite the EC/KBC only when instructed by a diagnostic disk release
notice.
2. Connect the AC adaptor to the computer when you rewrite the EC/KBC.
3. Do not turn off the power while you are rewriting the EC/KBC.
If the rewrite fails, it might be impossible to start up the computer.
4. If you fail to rewrite EC/KBC, then when you next turn on the power, a
message may be displayed that the contents of the EC/KBC has been erased.
In this case, insert the BIOS/EC/KBC rewriting disk, and the EC/KBC will
be rewritten.
5. Normally it takes about 30 seconds to rewrite the EC/KBC. It may take 3
minutes (maximum), depending on the conditions of the computer or ICs.
The computer is not hung up. Allow sufficient time. Never reboot or turn
off the power to the computer before the rewriting is completed.
1. Set the system to boot mode.
2. Turn off the computer.
3. Remove the external cable and PC Card.
4. Insert the BIOS/EC/KBC rewriting disk into the built-in FDD.
5. Turn on the power while holding down the [Tab] key. Keep holding down the key
until a message appears on the screen.
6. When the EC/KBC rewrite is completed, the system is automatically turned off.