Filter
Top Products
2 Troubleshooting Procedures 2.6 HDD Troubleshooting
2-36 Satellite Pro M10 Series Maintenance Manual (960-431)
Procedure 4 Diagnostic Test Program Execution Check
The HDD test program is stored in the diagnostics disk. Perform all of the HDD tests in the Hard
Disk Drive Test. Refer to Chapter 3, Tests and Diagnostics, for more information about the
HDD test program.
If an error is detected during the HDD test, an error code and status will be displayed. The error
codes and statuses are listed in Table 2-5. If an error code is not generated and the problem still
exists, go to Procedure 5.
Table 2-5 Hard disk drive error code and status
Code Status
01h Bad command
02h Bad address mark
04h Record not found
05h HDC not reset
07h Drive not initialized
08h HDC overrun (DRQ)
09h DMA boundary error
0Ah Bad sector error
0Bh Bad track error
10h ECC error
11h ECC recover enable
20h HDC error
40h Seek error
80h Time out error
AAh Drive not ready
BBh Undefined error
CCh Write fault
E0h Status error
EEh Access time out error
DAh No HDD