Filter
Top Products
Power module setup Error codes
241 Power Module has failed its self-test.
242 Internal Communications response by the Power Module was in error.
244 Power Module did not respond with RDY.
247 The Power Module reported spec data did not match the internal table.
Errors detected during Retain or Recall
248 Internal Communications Time Out - Power Module not installed.
Main
Controller
Power Modules Communications errors
1 Error during channels scan (power-on).
2 Power Module’s response to status query was in error.
3 Communications Interrupt Line is asserted and no Power Module responded
to scan.
4 Internal communication receive buffer was full.
16 Internal Communications Time Out for Power Module in channel 1.
17 Internal Communications Time Out for Power Module in channel 2.
18 Internal Communications Time Out for Power Module in channel 3.
19 Internal Communications Time Out for Power Module in channel 4.
20 Internal Communications Time Out for Power Module in channel 5.
21 Internal Communications Time Out for Power Module in channel 6.
22 Internal Communications Time Out for Power Module in channel 7.
23 Internal Communications Time Out for Power Module in channel 8.
24 Internal Communications Time Out for Power Module in channel 9.
25 Internal Communications Time Out for Power Module in channel 10.
26 Internal Communications Time Out for Power Module in channel 11.
27 Internal Communications Time Out for Power Module in channel 12.
28 Internal Communications Time Out for Power Module in channel 13.
29 Internal Communications Time Out for Power Module in channel 14.
30 Internal Communications Time Out for Power Module in channel 15.
31 Internal Communications Time Out for Power Module in channel 16.
RS232 Communications errors
32 Data received while DTR was off (receive buffer is full).
33 Transmit buffer is full.
34 Receive Parity Error.
GPIB Communications errors
48 Bus Error (reported by hardware).
49 Input Queue was full so the Bus Trigger command cannot be executed.
50 Input Queue was full so the EOI message (set on last character which is not
a LF) cannot be processed.
94 XMP 2600 User’s Guide rev. 1.0