Filter
Top Products
Programming power module parameters Basic operation
Parameter Value Lower limit Upper limit
Voltage Vset Vmax
LIM
Current Iset Imax
Voltage Vset Vmax
HIGH
Current Iset Imax
Voltage 0V Vset
LOW
Current 0A Iset
Displayed entry guidance (limit value)
When you program a value for a parameter that has voltage and current values, the
right side of the display’s upper row shows the most relevant limit on the allowed
value to program. The table below summarizes the displayed limiting values:
Parameter Value Displayed limit Remarks
Voltage
Upper: LM or
OV
The lower of Vlim or OVset
SET
Current
Upper: LM or
OC
The lower of Ilim or OCset
Voltage Lower: SE Vset
PROT
Current Lower: SE Iset
Voltage Upper: MX Vmax
LIM
Current Upper: MX Imax
Voltage Lower: SE Vset
HIGH
Current Lower: SE Iset
Voltage Upper: SE Vset
LOW
Current Upper: SE Iset
Limit indication
When you try to program a value outside its allowed range, the value is not accepted
and a warning message (“*** VALUE LIMIT ***”) is displayed on the display’s
lower row.
If the internal buzzer is set to “always” (see the chapter on power supply setup) – a
short beep will be heard as well.
46 XMP 2600 User’s Guide rev. 1.0