Filter
Top Products
Running the sequence program Sequence programming
Exit
sequence
program
editing mode
Press the SET key to exit sequence program editing mode and return the Power
Supply to status mode.
Running the sequence program
Activate the
sequence
program
To activate the sequence program proceed as follows:
Move the cursor to the system symbol (“Σ”) and make sure the power
supply is displaying global system status. Use the table below as a
guide on how to get there.
IF… Take the action…
Operating in programming
mode (an underline cursor
is visible at the upper row
of the display)
Press the
SET key to exit programming
mode and press the SYSTEM key to move
the cursor to the system symbol.
The cursor is not at the
system symbol (“Σ”)
Method 1: Press the
SYSTEM key to move
the cursor to the system symbol.
Method 2: if the cursor (blinking black
rectangle) is at the lower row of
the display you can use the
selection keys ← → to move
the cursor to the system symbol.
The cursor is at the system
symbol but the upper row
shows other information.
Press the
SYSTEM key, examine the
information on the upper row of the display
and act accordingly.
The cursor is at the system
symbol but the upper row
reads: “Power Supply Set
Up”
Press the
SET key to exit the setup mode
and return to status mode.
You are unable to get the
display you want using the
instructions above.
Reset the power supply:
Method 1: Press and hold the
DEL key and
then press LOCAL - the two
keys must be pressed together.
Method 2: recycle power using the line
switch.
Press the RCL key to initiate sequence program run mode.
A confirmation message is displayed: “PRESS ENTER TO START
PROGRAM”.
o Press ENTER to start execution of the sequence program.
o Press any other key to abort.
74 XMP 2600 User’s Guide rev. 1.0