Filter
Top Products
First operation steps Step 3: globally enable power modules outputs (global on)
output is on (enabled).
output is off (disabled).
For details on the condensed status symbol of a power module, please refer to the
section on reading status, earlier in this chapter.
Exit
programming
mode
Press the
SET key to exit programming mode. The cursor returns to the lower row
of the display and the upper row shows SET values (in status mode).
Press the UP selection key to change the display to show LOAD (output) values.
Step 3: globally enable power modules outputs
(global on)
Turning on a specific power module is not sufficient for enabling its output.
In addition to controlling the state of the individual power module’s output, the
XMP 2600 has a global output enable/disable feature (global on).
The OUT indicator, at the lower right corner of the front panel, indicates the state of
the global output enable feature. When the indicator is on – outputs are globally
enabled.
Global output enable will not turn on (enable) power modules that
their outputs are individually turned off (disabled).
Start from
status mode
Make sure the cursor (blinking black rectangle) is at one of the following positions:
♦ The cursor is at the system symbol (“Σ”) and the upper row of the display
shows the global power supply status.
♦ The cursor is at one of the condensed power module status symbols and the
upper row of the display shows power module status information.
Use the table below if you need to get the display to the state described above:
IF… Take the action…
Operating in programming mode
(an underline cursor is visible at
the upper row of the display)
Press the
SET key to exit programming
mode.
The cursor is at the system
symbol but the upper row shows
other information.
Press the
SYSTEM key, examine the
information on the upper row of the display
and act accordingly.
The cursor is at the system
symbol but the upper row reads:
“Power Supply Set Up”
Press the
SET key to exit the setup mode
and return to status mode.
You are unable to get the display
you want using the instructions
above.
Reset the power supply:
Method 1: Press and hold the
DEL key and
then press LOCAL - the two keys
must be pressed together.
Method 2: recycle power using the line
switch.
XMP 2600 User’s Guide
rev. 1.0 41