Filter
Top Products
Commands 113
6-00020-02
SNC 5100
Each command outputs a status “value” in decimal and hexadecimal after
execution and before a new prompt is displayed.
Example:
value=0=0x0
scsiTermGet Display termination status information for
SCSI Channels
161
scsiTermSet Set termination status for the selected
channel
161
targets Display attached SCSI and Fibre Channel
Target devices
180
Startup
diagBoot Shutdown and restart in Diagnostic mode 191
normalBoot Shutdown and restart in Normal mode 150
reset Restart without shutdown 151
reboot Shutdown and restart 151
Time and Date
date Display the date and time 115
dateSetFromRTC Set the Real Time Clock as the source of
date display
116
hostShow Display the IP address of the system
timeserver
138
rdate Set a remote system as the source of date
display
150
rtcDateSet Manually set the Real Time Clock 154
rtcSetCurrent Synchronize the Real Time Clock with the
timeserver
155
setNettime Enable or disable timeserver functionality 163
setTimeHost Add a host running timeserver to the system 164
tzSet Set the time zone offset from Greenwich
Mean Time
183
Table 13: Commands Listed Alphabetically byFunction
Command or Command
Group
Description Page