Filter
Top Products
SNC 5100
166 Commands
6-00020-02
SN60023 >
If SFM is already active, the following is displayed.
SN60023 > sfmActiveSet
SFM: Already Active
value = 21 = 0x15
SN60023 >
sfmConnectionSet [hostindex],“host connection string”
The sfmConnectionSet command sets the host connection information for
the host at the specified connection index. The connection may be a device
name, port address, etc. The following example shows setting the host
connection information. Existing hostindex values can be determined by
looking at the “Id” column in the output of the
sfmShow -1 command.
SN60023 > sfmConnectionSet 1,"ScsiPort2 [0:0:0] (QLA2100)"
value=0=0x0
SN60023 >
sfmFeatureEnable “license key string”
The sfmFeatureEnable command enables the SFM feature. Each license key
is unique for each Pathlight 5000SNC 5100 serial number. If the feature is
factory-enabled you can specify “enable” rather than an actual license key.
sfmHostShow [hostIndex]
The sfmHostShow command displays all known Scalar Firewall Manager
information for the specified host connection index. The LUN access map is
displayed as 16 rows of 16 bytes, one byte for each LUN.
hostIndex is the Id obtained from the sfmShow command.
00 in the LUN Access map indicates the host has no access to the LUN.
01 in the LUN Access map indicates the host has access to the LUN.
The following command example shows SFM information for host Id 1.
SN60023 > sfmHostShow 1
Host(1):
State = 0, Type = 1, Flags = 0x00000000, Online
WWN: 200000e0:8b0057d8