ADIC SNC 5100 Network Card User Manual


 
Final Diagnostic Tests 85
6-00020-02
SNC 5100
Step 7. From the Service Terminal, enter the showBox command.
For more information, see the
"showBox" command on page 194.
Step 8. Verify that the SNC 5100 accurately displays the channel
information.
If the
showBox display is accurate, go to step 9.
If not, go to Start MAP on page 42.
Step 9. Proceed to "Fibre Channel Tests"
Fibre Channel Tests
For further information about the procedures and commands used in this
section, see Connecting to the Service Port on page 95 and Diagnostic
Command Reference on page 187.
Test Fibre Channel Port 1
Step 1. Attach the Fibre Channel loop back plug to the GBIC in FC 1.
Step 2. From the service terminal, enter the fcSlotTest 1 command.
For more information, see the "fcSlotTest [x]" command on
page 192.
Step 3. If the test passes, remove the loop back plug and go to "Test Fibre
Channel Port 2".
If the test does not pass, go to Start MAP on page 42.
Test Fibre Channel Port 2
Step 1. Attach the Fibre Channel loop back plug to the GBIC in FC 2.
Step 2. From the service terminal, enter the fcSlotTest 2 command.
For more information, see the "fcSlotTest [x]" command on
page 192.