ADIC SNC 5100 Network Card User Manual


 
Commands 163
6-00020-02
SNC 5100
interface. This provides some customization in the way the SNC 5100 is
presented to the particular operating system. If [port] is 0, the change applies to
all SAN connections; otherwise the host type is applied to the specified port.
Caution
You must reboot the SNC 5100 after executing this command for
the new setting to take effect.
setNettime [value]
The
setNettime command enables or disables timeserver functionality.
Parameter Value
Port 0 Changes will apply to all FC
Connections
1 or 2 Changes will apply to FC Connection 1
or 2, as specified
OS nt
aix
solaris
hp-ux
linux
netware
gateway
generic
unisys
as400
adic snc
pv-136t-fc
autosense/nt
Value Meaning
0 Disables timeserver functionality
1 Enables timeserver functionality