Filter
Top Products
SNC 5100
88 Network Setup for the SNC 5100
6-00020-02
Figure 8 Ethernet Port
Step 1. To configure the network, connect to the SNC 5100 Service Port.
For more information, see “Connecting to the Service Port” on
page 95.
In all of the subsequent steps, substitute the values you determined
in Step 6 of Table 2, “Pre-Installation Checklist,” on page 19.
Step 2. Enter the
hostNameSet command to set the Host name.
For more information, see the "hostNameSet" command on page
138.
In the example shown, the host name of the SNC 5100 was
“SN60023” and is now being set to “foster.” The shell prompt will
change to reflect the new name.
Example:
SN60023 > hostNameSet "foster"
Target hostname set to foster
value=0=0x0
foster >
Step 3. Use the ethAddrSet command to set the host network address:
For more information, see the "ethAddrSet" command on page
121.
The IP address is specified as four decimal numbers, separated by
periods.
Example:
foster > ethAddrSet "192.168.1.54"
Host Address set to 192.168.1.54 for Ethernet interface
value=0=0x0