ADIC SNC 5100 Network Card User Manual


 
Commands 127
6-00020-02
SNC 5100
typically use this command to restart the port after changing its configuration
settings so that the changes take effect. Issuing this command is an alternative
to rebooting the SNC 5100 in order to make the configuration changes take
effect.
Caution
This command interrupts traffic.
The following example shows the display when Fibre Channel port 1 is
specified.
SN60023 > fcRestart 1
value=0=0x0:
Restart of FC Channel 1 succeeded
In order to get the command prompt (e.g. SN60023 >) to show after you have
executed the
fcRestart command, you will need to press the Enter key.
fcShow [level]
The
fcShow command displays the channel status for each Fibre Channel
interface.
Parameter Value Meaning
Port 1 The SNC 5100 connection labeled FC1
2 The SNC 5100 connection labeled FC2
Level Meaning
0 or
<blank>
sets the verbosity level to the display in the example below
1 displays the information displayed below, and appends a break-out for each
channel that includes Node Type, Node Name, Port Name and Port ID
2 displays the information included at levels 0 and 1, and appends loop ID
link stats