Filter
Top Products
SNC 5100
72 Ethernet MAP
6-00020-02
lo (unit number 0):
Flags: (0x8069) UP LOOPBACK MULTICAST ARP RUNNING
Type: SOFTWARE_LOOPBACK
Internet address: 127.0.0.1
Netmask 0xff000000 Subnetmask 0xff000000
Metric is 0
Maximum Transfer Unit size is 32768
0 packets received; 0 packets sent
0 multicast packets received
0 multicast packets sent
0 input errors; 0 output errors
0 collisions; 0 dropped
value = 29 = 0x1d
Step 15. If there is no entry for ibmEmac, replace the SNC 5100.
Go to “Before Removing or Replacing the Unit” on page 82.
Continue through “Replacing the SNC 5100” on page 84.
Exit this MAP.
If there is an entry for ibmEmac, write down the values of the:
- internet address,
- netmask,
- subnetmask
Step 16. Verify that the internet address is the same as the IP address
supplied by the network administrator.
Step 17. Verify that the netmask value is the same as the netmask in hex
format supplied by the network administrator.
Step 18. Verify that the subnetmask is the same as the netmask. If these
values are correct, go to step 21.
If these values are not correct, proceed to Step 19.
Step 19. Use the ethAddrSet command to set the correct IP address and
netmask values.
For more information, see the
"ethAddrSet" command on page
121.