ADIC SNC 5100 Network Card User Manual


 
SNC 5100
50 SCSI Channel MAP
6-00020-02
If all of the attached SCSI devices are not displayed, go to SCSI Channel
MAP on page 50.
Check Channel Zoning Settings
Step 1. Enter the fcShowDevs command from the service terminal.
For more information, see the "fcShowDevs" command on page
129.
Look at the display for each Fibre Channel interface. If all of the
SCSI devices are displayed under each Fibre Channel interface,
then host access to SCSI devices is not being restricted by Channel
Zoning.
Step 2. Use the ADIC Management Console to change Channel Zoning
settings.
For information on Channel Zoning, see the ADIC Management
Console User Guide.
SCSI Channel MAP
Perform these steps if:
Errors are reported on the SCSI bus
SCSI I/O fails to operate
Parity errors are detected on the SCSI bus
SCSI device reports unit attention on non-removable device
Unexpected SCSI bus reset occurs
Unexpected SCSI disconnect reported by a SCSI device
Get SCSI Information for the SNC 5100
Step 1. Connect a service terminal to the SNC 5100.
For information about how to do this, see Connecting to the
Service Port on page 95.