ADIC SNC 5100 Network Card User Manual


 
Hardware Product Description and Features 13
6-00020-02
SNC 5100
LUN for command and control so that the remaining 2047 LUNs are
available for SCSI devices. For each Fibre Channel interface, the SNC
5100 occupies one Fibre Channel ID and all SCSI target devices are
available as LUNs on the same Fibre Channel ID.
The maximum number of initiators that can be connected via SCSI
Channel is 1 per SCSI Channel.
The unit provides four SCSI-3 VHDCI connectors for maximum
mechanical reliability.
The SCSI interfaces are compliant with the following SCSI specifications:
ANSI X3T9.2 375D Rev. 101, SCSI - 2
ANSI T10/1142D Rev 20b, SCSI-3 Parallel Interface-2
SCSI Command Support
SCSI-3 SCSI Architecture Model - 2 (SAM-2)
SCSI-3 SCSI Primary Commands - 2 (SPC-2)
SCSI-3 SCSI Block Commands - 2 (SBC-2)
SCSI-3 Stream Commands (SSC)
SCSI-3 Medium Changer Commands (SMC)
SCSI-3 Multi-Media Commands - 2 (MC-2)
SCSI-3 Controller Commands - 2 (SCC-2)
Ethernet
The 10/100 Base-T Ethernet port has an RJ-45 connector for out-of-band
management. It can be connected to a network hub, switch, or router using an
unshielded twisted-pair Ethernet cable. The Ethernet port complies with the
IEEE 802.3 specification.
Service Port
The service port is an RS-232 connection with a 9-pin D-shell connector
(DTE). It connects to the host serial port with a 9-pin to 9-pin null-modem
cable. It is compatible with serial ports on personal computers.