ADIC SNC 5100 Network Card User Manual


 
SNC 5100
174 Commands
6-00020-02
For more information, see the ADIC Management Console User Guide.
SN60023 > snmpWriteCommunityAdd adic,1
Success
value=0=0x0
SN60023 >
snmpWriteCommunityRemove string
The
snmpWriteCommunityRemove command removes the specified string
from the list of accepted strings for SNMP Write operations.
SN60023 > snmpWriteCommunityRemove adic
Success
value=0=0x0
SN60023 >
sysConfigShow
The
sysConfigShow command displays current system parameter settings.
The display shows whether or not the SNC 5100s Command and Control
interface is enabled or disabled and the LUN that is assigned to it, whether or
not enhanced tape performance features are enabled, the MAC address of the
Ethernet port; and the SNC 5100s Fibre Channel Node address.
SN60023 > sysConfigShow
Current System Parameter Settings:
Command and Control Device (CC) : 0 Enabled
LUN : 0
Allow Early Write Status for Tape : 1 Enabled
Allow R/W Acceleration for Tape : 1 Enabled
Enet MAC Address: 0.60.45.16.1.4
FC Node WWN: 10000060.45160104
value=0=0x0
SN60023 >
sysNodeNameModeSet [Mode]
The
sysNodeNameModeSet command changes the Fibre Channel Node Name
Mode for the Fibre Channel interface ports. In the default mode (Mode 0), each
Fibre Channel port on the SNC 5100 has the same node name. For
configurations that require the node name to be different, use the
sysNodeNameModeSet command to change the mode to 1.