ADIC SNC 5100 Network Card User Manual


 
SNC 5100
46 Start MAP
6-00020-02
Step 3. Issue the sysVpdShow command.
For more information, see the
"sysVpdShow or
sysVpdShowAll"
command on page 175.
Step 4. Report this information to your service representative, if you are
asked for it.
Quick Component Check
Use this procedure to check system components:
Step 1. Connect a service terminal to the SNC 5100.
For information about how to do this, see Connecting to the
Service Port on page 95.
Step 2. Press the Enter key on the service terminal.
If the prompt is not displayed, go to Service Port MAP on
page 75.
Step 3. From the service terminal, enter the
showBox command.
For more information, see the "showBox" command on page 170.
Step 4. If an installed component does not show up in the display, go to the
correct MAP.
For example, if a SCSI interface is missing, go to "SCSI Channel
MAP" on page 50.
If a Fibre Channel is missing, go to "Fibre Channel MAP" on
page 61.
Step 5. If all components display properly, proceed to "Perform Health
Check".
Perform Health Check
Step 1. Stop all I/O.
Step 2. Remove the Ethernet cable if installed.