ADIC SNC 5100 Network Card User Manual


 
SNC 5100
190 Special Procedures
6-00020-02
This event is also recorded in the SNC 5100 event log along with the name of a
file that was saved to the flash file system. The file contains information about
the state of the Fibre Channel interface prior to the reset.
Follow these steps to retrieve the file.
Step 1. Connect the service terminal to the Service Port.
For more information, see Connecting to the Service Port on
page 95.
Step 2. Press the Enter key on the service terminal.
If the prompt is not displayed, go to Service Port MAP on
page 75.
Step 3. From the service terminal, navigate to the DUMP directory by
entering the
cd /ffs/dump command.
Step 4. From the service terminal, enter the ls command to get a file listing
for the directory.
There may be more than one file present if the error condition has
occurred more than once.
Caution
Dump file names end in .
dmp and the files are automatically deleted
whenever you update the SNC 5100s firmware.
Step 5. Refer to the section Saving a Configuration File on page 99.
Substitute the name of the dump file and use that procedure to save
the file to the service terminal.
Repeat this step if there is more than one file.
Save each file to the service terminal.
Step 6. Send the file to support@adic.com for analysis, attaching the dump
file to the message.