Filter
Top Products
Network Setup for the SNC 5100 89
6-00020-02
SNC 5100
If you need to set a netmask, specify it after the network address:
Example:
foster > ethAddrSet “10.0.0.2”, “255.0.0.0”
If you need a network route and/or default gateway, you must
specify it.
Example:
foster > gateAddrSet "192.168.1.1"
value=0=0x0
When more complicated routing is required, use the route
command to specify the destination address, as a full address
(single host) or as an abbreviated subnet address.
Specify the address of the gateway that is reachable on the local
subnet.
Example:
foster > route "add", "206.0.0", "192.168.1.1"
value=0=0x0
Step 4. Optionally, add User account for Telnet
If you want to access the SNC 5100’s command line interface
through its Ethernet port using a Telnet session, you need to add a
user account.
The user name you specify must be 3 or more characters. The
password you specify must be 8 or more characters.
For more information, see the commands beginning with
user in
the “Service Port Command Reference” on page 105.
Example:
foster > userAdd “username”,”password”
value=0=0x0
foster >
Step 5. Enter the reboot command to reboot the SNC 5100:
For more information, see the
"ethAddrSet" command on page 121.
Example:
foster > reboot