ADIC SNC 5100 Network Card User Manual


 
SNC 5100
20 Installation Procedure
6-00020-02
Installation Procedure
The installation checklist has instructions on how to install the SNC 5100 with
SCSI attached storage and Fibre Channel attached hosts.
5
Label both ends of each SCSI cable
with:
° Drive ID and SNC 5100 connector
number
None.
6
If you are using the ADIC
Management Console to manage the
SNC 5100, configure an Ethernet
environment. Decide on network
parameters:
Ethernet port configuration decisions:
Static IP address____________
Netmask (if required)_________
User-defined SNC 5100 name
(optional)__________________
You may need to assign a default
network gateway address and/or route
table entries:
________________________
Caution: Save this configuration
information for future reference.
For more information, see the ADIC
Management Console User Guide.
Obtain the network parameters from
your network administrator.
Caution: Use of incorrect network
parameters can cause problems on the
Ethernet network.
The default network name is the units
serial number. If you choose a different
name, it becomes the prompt displayed
on the service terminal. Choosing a
different name may be useful if you have
more than one SNC 5100. To change the
name, use the
"hostNameSet"
command on page 138.
7
If you are using the ADIC
Management Console to manage the
SNC 5100, run the Ethernet cable
from the server (the computer that is
designated to run the management
softwares Server) to the network hub.
For more information, see the ADIC
Management Console User Guide.
Table 3: Installation Checklist
Step Actions Comments and References
1
Acquire information for Ethernet
installation.
Refer to Step 6 in Table 2: Pre-Installation
Checklist.
Table 2: Pre-Installation Checklist
Step Actions Comments and References