Filter
Top Products
Section 5 User Interface Guide TRACER 6000 Series Integrated System Manual
84 Copyright © 2005 ADTRAN, Inc. 612806420L1-1F
> FIRMWARE UPGRADE UTILITY
Figure 33 shows the Firmware Upgrade Utility menu page, which contains the parameters for performing a
firmware upgrade for the local and remote systems.
Figure 33. Firmware Upgrade Utility
> FIRMWARE UPGRADE UTILITY > FILE XFER METHOD
Lists the available transfer methods for updating the TRACER 64x0 system. The following selections are
available:
> FIRMWARE UPGRADE UTILITY > TFTP SERVER
(Available for TFTP transfers only.) Configures the IP address of the TFTP server on which the update file
resides. The TRACER 64x0 uses this field to locate the network TFTP server and request the file transfer.
> FIRMWARE UPGRADE UTILITY > TFTP FILENAME
(Available for TFTP transfers only.) Specifies the name of the update file to retrieve from the TFTP server.
Enter the full filename for the file. Some TFTP servers require the full path name for any file not located in
the default directory. Refer to the TFTP software documentation for more details.
TFTP LOCAL MGMT PORT
Upgrade the firmware using a trivial file transfer protocol (TFTP)
server that is located on the same Ethernet network as the local
system. TFTP transfers files by specifying an appropriate server
address and filename.
TFTP REMOTE MGMT PORT
Upgrade the firmware using a TFTP server that is located on the same
Ethernet network as the remote system. TFTP transfers files by
specifying an appropriate server address and filename.
XMODEM
Upgrade the firmware using XMODEM software on a terminal or PC
that is connected to the
CRAFT interface of the local system.