Filter
Top Products
Section 6 DLP-1 TRACER 6000 Series Integrated System Manual
92 Copyright © 2005 ADTRAN, Inc. 612806420L1-1F
1. Connecting a VT100 terminal to the TRACER 64x0:
2. Connecting a PC emulating a VT100 terminal to the TRACER 64x0:
Most PCs or laptops can run communications software that emulates a VT100 terminal. Examples
include Windows programs such as Terminal
® or Hyperterminal®. However, there are many other
adequate, commercially available software packages which will allow your PC or laptop to emulate a
VT100 terminal.
You are now ready to log in to the TRACER 64x0 as described in DLP-2, Logging into the TRACER 64x0, on
page 93.
Perform one of the following steps:
• Set the parameters of the VT100 terminal or PC to match the default settings on the
TRACER 64x0:
– 9600 baud rate
– 8 data bits
– No parity
– 1 stop bit
– No flow control
• If the terminal has a parallel setting, disable this setting and use the serial port.
Using the CRAFT Port
• Plug the DB-9 male end of the data cable into the TRACER 64x0 CRAFT port on the front
of the unit. Make the connection to the VT100 terminal as appropriate for your equipment.
• Set the parameters of the communications software to match the default settings on the
TRACER 64x0:
– 9600 baud rate
– 8 data bits
– No parity
– 1 stop bit
– No flow control
• Set the PC for direct connect (instead of dial up connection) on the appropriate com port.
Using the CRAFT Port
• Plug the DB-9 male end of the data cable into the TRACER 64x0 CRAFT port on the front
of the unit. Make connection to the PC or laptop as appropriate for your equipment.