Filter
Top Products
612806420L1-1F Copyright © 2005 ADTRAN, Inc. 95
DLP-3 Setting IP Parameters for the TRACER 64x0
Introduction
If the TRACER 64x0 is connected to an IP network for Telnet, TFTP, or SNMP management, several IP
parameters must be set for the unit to communicate with the network. These parameters are described in
this DLP along with the procedures for setting them.
Prerequisite Procedures
This procedure assumes that the TRACER 64x0 unit is connected to an IP network and is powered up.
Please see your Network Administrator for the proper assignment of the following
parameters:
IP ADDRESS, SUBNET MASK, and DEFAULT GATEWAY.
To prevent electrical shock, do not install equipment in a wet location or during a
lightning storm.
Electronic equipment can be damaged by static electrical discharge. Before handling it,
put on an antistatic discharge wrist strap to prevent damage to electronic components.
Place equipment in antistatic packing material when transporting or storing. When
working on equipment, always place it on an approved antistatic mat that is electrically
grounded.