Filter
Top Products
Chapter 8. Device Management
131
RADIUS Settings
To allow authentication and authorization for the KVM Over the NET
TM
switch
through a RADIUS server, do the following:
1. Check Enable.
2. Fill in the IP addresses and port numbers for the Preferred and Alternate
RADIUS servers.
3. In the Timeout field, set the time in seconds that the KVM Over the NET
TM
switch waits for a RADIUS server reply before it times out.
4. In the Retries field, set the number of allowed RADIUS retries.
5. In the Shared Secret field, key in the character string that you want to use
for authentication between the KVM Over the NET
TM
switch and the
RADIUS Server.
6. On the RADIUS server, set the entry for each user as follows:
su/xxxx
Where xxxx represents the Username given to the user when the account
was created on the KVM Over the NET
TM
switch. The user’s access rights
are the ones assigned for the KVM Over the NET
TM
switch, as well.
(See Adding Users, page 107.)
kn2124v-4132.book Page 131 Tuesday, January 12, 2010 5:08 PM