Filter
Top Products
KVM Over the NET™ User Manual
132
LDAP / LDAPS Authentication and Authorization Settings
To allow authentication and authorization for the KVM Over the NET
TM
switch
via LDAP / LDAPS, refer to the information in the table, below:
Note: If LDAP Settings is enabled, the LDAP schema for MS Active
Directory must be extended. See LDAP Server Configuration,
page 173, for details.
CC Management Settings
To allow authorization for the KVM Over the NET
TM
switch through a CC
(Control Center) server, check Enable and fill in the CC Server’s IP address
and the port that it listens on in the appropriate fields.
Item Action
Enable Put a check in the Enable checkbox to allow LDAP / LDAPS
authentication and authorization.
Type Click a radio button to specify whether to use LDAP or LDAPS.
LDAP Server IP and
Port
Fill in the IP address and port number for the LDAP or LDAPS
server. For LDAP, the default port number is 389; for LDAPS,
the default port number is 636.
Admin DN Consult the LDAP / LDAPS administrator to ascertain the
appropriate entry for this field. For example, the entry might
look like this:
ou=kn4132,dc=aten,dc=com
Admin Name Key in the LDAP administrator’s username.
Password Key in the LDAP administrator’s password.
Search DN Set the distinguished name of the search base. This is the
domain name where the search starts for user names.
Timeout
Set the time in seconds that the
KVM Over the NET
TM
switch waits for an LDAP or LDAPS server reply before it times
out.
kn2124v-4132.book Page 132 Tuesday, January 12, 2010 5:08 PM