ATEN Technology KN4140V Switch User Manual


 
KVM Over the NET™ User Manual
8
Video
Only the following non-interlaced video signals are supported:
KVM Adapter Cables
Cat 5e (or higher) cable is required to connect the KVM Over the NET
TM
switch to the KVM Adapter Cables (see page 21).
The following KVM Adapter Cables are required for use with the KVM
Over the NET
TM
switch:
Note: 1. The KVM Adapter cables marked with an asterisk (*) are for use with
the KN2124v, KN2140v, KN4124v and KN4140v switches only.
2. If you use Adapter Cables that were purchased prior to your switch
purchase, you may have to upgrade the Adapter Cable’s firmware.
You can upgrade the Adapter Cable’s firmware from the
Maintenance page (see page 149 for details).
Resolution Refresh Rates
640 x 480 60, 70, 72, 75, 85
720 x 400 70, 75
800 x 600 56, 60, 70, 72, 75, 85
1024 x 768 60, 70, 75, 85
1152 x 864 60, 70, 75, 85
1152 x 900 66, 76
1280 x 1024 60, 70, 75, 85
1600 x 1200 60
Function Module
Connect to devices with PS/2 ports KA9120 / KA7120
Connect to devices with USB ports
(All platforms – PC, Mac, Sun)
KA9170 / KA7170
Connect to Sun Legacy Computers KA9130 / KA7130
Connect to serial based devices KA9140 / KA7140
Connect to devices with USB ports and virtual
media support
KA7175*
Connect to devices with USB ports, virtual
media and audio support
KA7176*
kn2124v-4132.book Page 8 Tuesday, January 12, 2010 5:08 PM