Filter
Top Products
KVM Over the NET™ User Manual
16
Stacking and Rack Mounting
The KVM Over the NET
TM
switch can be stacked on the desktop or rack
mounted in a variety of ways. The following sections take you through the
procedures for each method.
Stacking
The KVM Over the NET
TM
switch can be placed on any appropriate level
surface that can safely support its weight plus the weight of its attached cables.
To place the KVM Over the NET
TM
switch, or to stack units if you are daisy-
chaining them, remove the backing material from the bottom of the rubber feet
that came with this package, and stick them onto the switch’s bottom panel at
the corners, as shown in the diagram, below:
Note: To ensure adequate ventilation, allow at least 5.1 cm on each side, and
12.7 cm behind the unit for power cord and cable clearance.
kn2124v-4132.book Page 16 Tuesday, January 12, 2010 5:08 PM