Filter
Top Products
2.9.1
System Restore
Use the following steps to perform a System Restore.
1. Plug the USB Recovery drive into one of the external USB 3.0 ports on
the Barco Media Server.
The Barco USB Recovery drive is a USB 3.0 device; you may reduce
recovery time by using this drive in a USB 3.0 port.
2.
Right-click the Windows icon at the lower left-hand corner of the
screen to restart.
As the system restarts, it displays the Barco logo screen.
3. Press and hold the F8 key to summon the Select Boot Device screen.
4. Select the USB Recovery drive (STT ST3U16SSPS (15000MB)).
Use the upand down arrowkeyson your keyboard,or useyour mouse
to make selections.
After the system restarts, the Restore application displays the Barco
Media Server Validation screen.
Figure 2.9. Barco Media Server Validation screen
5. Allow the System Restore menu to load.
The System Restore menu takes a few minutes to load. During this
time, a number of small windows appear and disappear. Wait until
you see a full-screen menu titled Barco Media System Restore Menu.
Barco Pn: 6060032036
Section 2: InstallationBarco Media Server XHD-Series User Guide