Filter
Top Products
7 - 5
AUTO DIAL NUMBERS AND DIALING OPTIONS
■ To stop the broadcasting in progress, press Stop. The LCD asks if you want to
cancel all locations or only the location that is being sent.
■ Enter the long dialing sequence numbers as you normally would, but keep in
mind that each key counts as one location, so the number of locations you can
call becomes limited.
■ If the line is busy or for some other reasons a connection could not be made
while broadcasting, the MFC will redial the number automatically.
■ If the memory is full, press Stop to abort the job or press Start to send the
portion that is in the memory (if more than one page has been scanned).
1
Place the original face up in the ADF, or face down on the scanner glass.
2
Enter a number using One Touch, Speed Dial, a Group number or Search.
Example: Group number
3
Press Set. You will be prompted to press the next number.
4
Enter the next number.
Example: Speed Dial
5
Press Set.
6
Enter the fax number.
Example: Manual dialing, using the dial pad.
7
Press Start.
Your MFC will read the original into memory and then start sending faxes to the
numbers you entered.
Access Codes and Credit Card Numbers
Sometimes you may want to choose from among several long distance carriers
when you make a call. Rates may vary depending upon the time and destination.
To take advantage of low rates, you can store access codes or long-distance
carriers as One Touch or Speed Dial numbers. You can store these long dialing
sequences by dividing them and setting them up on separate keys in any
combination. You can even include manual dialing using the dial pad. The
combined number will be dialed in the order you entered it, as soon as you press
Start. (See
Storing One Touch Dial Numbers, page 7-1.)
For example:
You can store “555” on One Touch key 3 and “7000” on One Touch key 2. If
you press One Touch 3, 2, and Start, you can dial “555-7000”. To temporarily
change a number, you can substitute part of the number with manual dialing
using the dial pad. For example, to change the number to 555-7001 you could
press One Touch 3 and press 7, 0, 0, 1 using the dial pad.
Note
If you must wait for another dial tone at any point in the dialing sequence, store
a pause at that point in the number by pressing Redial/Pause. Each key press
adds a 3.5 second delay.