Cabletron Systems CSX1200 Switch User Manual


 
Workgroup Remote Access Switch 159
C
ONFIGURING
D
EVICE
L
EVEL
D
ATABASES
On-node Device Entries
If you select PVC, the list of available PVCs are displayed. The LCN of the selected PVC and
the X.25 Access Name are stored in the Device Table to bind the device to a particular virtual
circuit configuration:
If you select SVC, you must enter the X.121 address of the remote DTE. You need the remote
DTE address to make the X.25 call to the proper remote device.
8. Enter the authentication information needed. To begin entering the information, select
Authentication from the Device Table Menu. The following menu will then be displayed:
Provide the necessary device authentication information for your selected Line Protocol. (Refer
to On-node Device Database Security Requirements for details). For example, for a PPP device,
specify a CHAP secret. Or, for an HDLC device, enter a Bridge Ethernet Address.
Select the type of the Virtual Circuit
1) Permanent Virtual Circuit (PVC)
2) Switched Virtual Circuit (SVC) [default 2]: 1
Current Permanent Virtual Circuits defined for X.25 Access #1, ’VMAX25’:
id Type LCN Protocol
-- ---- ---- --------
1 PVC 1 RFC877
2 PVC 2 RFC877
Id of Virtual Circuit to associate with device "vma",
or <RET> to cancel? 1
Select the type of the Virtual Circuit
1) Permanent Virtual Circuit (PVC)
2) Switched Virtual Circuit (SVC) [default 2]: 2
Enter the X.121 Address of the Remote DTE
or press <RET> to cancel? 9987654321
Device Authentication Menu: (device = "DAN")
PPP:
1) PAP Password ""
2) CHAP Secret ""
3) Outbound Authentication ENABLED
4) User Level Authentication DISABLED
IP Host (RFC 1294):
5) IP Host Id ""
HDLC Bridge:
6) Bridge Ethernet Address ""
7) Bridge Password ""
ISDN:
8) Calling Line Id(s) ""
Select function from above or <RET> for previous menu: