Cabletron Systems CSX1200 Switch User Manual


 
USER’S GUIDE
516 CyberSWITCH
cs
Displays the list of connected devices along with the data rate for each device. The output for
this command contains the connection time for each device along with a detailed breakdown
(per connection type) of channel usage and available data rates. If there is at least one device
connected, the display will look as follows. Note that a “more” mechanism will be used when
the number of connected devices exceeds a full screen. If there are no devices connected, the
cs
command does not produce any output.
dr
Displays reports of system messages. Refer to the chapters titled System Messages or Trace
Messages for message definitions.
ds
Displays system statistics. For details on the available system statistics refer to the System
Statistics chapter.
list [file name]
Displays the indicated file.
For example, to display the Release Notes, enter the following command:
list rel_note.txt
The “more” mechanism is used to view the indicated file. To view the next section of the file,
simply press any key (except
<escape>
). The system will automatically return to the normal
system prompt after the entire file has been displayed. If you are viewing the Release Notes,
press the
<escape>
key to exit the release notes and continue with the installation.
If the file name is incorrect, the following message will be displayed:
Cannot find file "file name"
mc
Displays the Connection Monitor screen. This screen provides information on the remote sites
to which the system is currently connected. The system updates the display as connections are
added or removed.
To display the Connection Monitor screen, Telnet and the terminal emulator must both be set
as the same terminal type. Use the
term set
command to do this.
Note:The
mc
command is also available if you are remotely connected to the CyberSWITCH
by Telnet.
neif
This command will display the system interface table. This table provides information for each
of the system’s physical interfaces, including interface name, interface type, slot and port
[System Name]> CS
Number of Channels Data Rate (Kbps) Connect Time
Device Name Swi Ded FrR X25 Tot Swi Ded FrR X25 Tot (hr:min:sec)
---------------- ------------------ --------------------- -----------
Tokyo 1 0 0 0 1 64 0 0 0 64 00:31:39
Ann Arbor 1 1 0 0 2 64 64 0 0 128 12:22:18
New York 4 0 0 0 4 256 0 0 0 256 04:02:22