Cabletron Systems CSX1200 Switch User Manual


 
USER’S GUIDE
90 CyberSWITCH
USING MANAGE MODE COMMANDS
resource
Displays the current resource configuration.
RESOURCE CONFIGURATION ELEMENTS
RESOURCE TYPE
The type of adapter (resource) that plug into the system. WAN adapters are the physical interface
for the attachment of lines (i.e., connections) to your system.
R
ESOURCE SLOT
The slot number into which the resource is plugged.
I
NTERNAL SWITCH TYPE
For ISDN resources (BRI and PRI) only. The switch type you wish to configure.
R
EGION
For NET3 and NET5 switchtypes. When configuring switches, first identify the region of operation,
and then the country.
C
OUNTRY
For the NET3 and NET5 switchtypes. The country in which the system is operating.
G
ENERIC NUMBER
For PRI_4ESS primary rate switch type only. The software load (generic #) the switch is running.
S
YNCHRONIZATION TYPE
For Primary adapters only. Every framed transmission line requires a clock source from which it
must derive the appropriate bit timing and channel timing relative to the start of a frame. For most
CPE gear, the clocking is derived from the received signal and the transmission clock is thus a
“slave” to the network. However, if the line is to provide its own clocking, it must derive a clock
from an internal source rather than a received signal. The line is then a “master” clock source.
RESOURCE BACKGROUND INFORMATION
The basic rate (BRI) resource directly terminates a standard USOC RJ45 connector. It is supplied
with a standard S/T interface. A U interface option is not available for this adapter. The BRI
resource supports 1 or 4 connections/ports depending on which option you purchase. It provides
support for the following switch types:
•NTT
•5ESS
DMS100
•NI1
•1TR6
•NET3
Definity
Legend
TS0-13