Filter
Top Products
USER’S GUIDE
542 CyberSWITCH
ip stats
Displays the current IP related statistics. Refer to IP Statistics, for a list of available statistics and
their definitions.
IPX ROUTING COMMANDS
IPX routing must be enabled before these commands can be used.
The following commands are used to display IPX routing information:
ipx ipxwan clear
Clears IPXWAN statistics.
ipx ipxwan stats (device)
Displays system-level IPXWAN statistics when device name not specified:
Displays Negotiation Parameters when device name specified and connected:
ipx diag <host ipx address> [timeout]
Tests device connectivity to specified IPX host by sending out a diag packet. If connection is up,
host sends a message in response to this packet to confirm receipt. The parameters for this
command are:
host ipx address
IPX address for the host, in <network number>:<node number> format. The network number
is a hexadecimal number up to eight digits in length. The node number is the host’s MAC
address. For example, if the assigned network number of “AAAA,” and the host has a MAC
address of 40AA68965439. For this example, you would enter “AAAA:40AA68965439” for the
host IPX address.
timeout
Optional parameter that indicates the number of seconds to wait for a reply. The valid range
for the time out value is 1 to 60 seconds. The default value is 10.
IPXWAN Statistics
Timer Request = Timer Response =
Information Request = Information Response =
Thruput Request = Thruput Response =
Delay Request = Delay Response =
NACK Sent = NACK Received =
Bad Packets =
WAN Statistics for device “xxxx”
Negotiation Parameters:
IPX Network Address = IPX Node Number =
Telebit Compression = Protocol =
WAN Link Delay =