Filter
Top Products
USER’S GUIDE
94 CyberSWITCH
datalink add
Allows you to add a data link. The following sample screen shows how a data link is added.
datalink change
Changes an existing data link.
datalink delete
Deletes an existing data link.
ampconf
Allows you to change the AMP port configuration.
LINE CONFIGURATION ELEMENTS
LINE NAME
A 1 to 16 user-defined character string (using all non-blank characters) that identifies the line. Each
line must have a unique name.
L
INE SLOT
The slot number assigned to the resource that will terminate this line.
L
INE PORT
The port number of the resource that will terminate this line.
L
INE INTERFACE TYPE
For basic rate lines only. Choice of point-to-point or point-multipoint. The point-to-point interface
type is the type most often used in the U.S.; point-multipoint is most often used in Japan.
A
UTO TEI
For basic rate lines only.The default setting for automatic TEI negotiation is “yes”. For #5ESS and
DMS100 lines, you should not change the setting. For NTT point-to-point lines, you should disable
the automatic TEI negotiation by answering “no” to the prompt for this feature.
Current LINE Configuration:
id LINE NAME TYPE SLOT PORT
--------------------------------------------------------------------------------
1 LINE.BASICRATE1 BR_ISDN 1 1
2 LINE.BASICRATE2 BR_ISDN 1 2
3 DMS100.LINE1 BR_ISDN 2 1
Select line id for new data link or press <RET> to cancel: 3<RET>
Automatic TEI negotiation (Y or N) [default = Y]? N<RET>
TEI value [default = 1]? <RET>
Service Profile ID (enter 0 for no SPID)
[default = NO SPID]? 13135551212<RET>
Directory number [default = 13135551212]? 5551212<RET>
Number of digits to verify [default = 7]? <RET>
The DATALINK configuration has been updated successfully.