Filter
Top Products
USER’S GUIDE
222 CyberSWITCH
BRIDGE FILTERS
CONFIGURING BRIDGE FILTERS
Note: Bridge dial out calls can be initiated through the use of a Known Connect list or through
the use of bridge filters. For a description of bridge dial out through bridge filters, refer to
the section titled Dial Out Using Bridge Filters.
U
SING CFGEDIT
1. Select Bridge Filters from the Bridging menu.
2. Configure any needed protocol definitions. These definitions will be used if you configure any
protocol filters. To configure a protocol definition:
a. Select to add a protocol definition.
b. Enter a user-defined name for the protocol definition.
c. Enter the Ethernet type in hex.
d. Enter the LSAP in hex.
3. Configure source MAC filters.
a. Select to add a MAC filter.
b. Enter the source MAC address.
c. Select a distribution list.
3. Configure destination MAC filters.
a. Select to add a destination MAC filter.
b. Enter the destination MAC address.
c. Select a distribution list.
5. Configure protocol filters.
a. Select to add a protocol filter.
b. Select a protocol definition Id.
c. Select a distribution list.
6. Configure packet data filters.
a. Select to add a packet data filter.
b. Enter the off set value.
c. Enter the mask in hex.
d. Enter the data value in hex.
e. Select a distribution list.
U
SING MANAGE MODE COMMANDS
Manage Mode can be used to complete all of the bridge filter configuration. This section provides
you with the commands available for each bridge filter type.