Cabletron Systems CSX1200 Switch User Manual


 
USER’S GUIDE
314 CyberSWITCH
3. Follow the onscreen instructions to keep the feature enabled.
4. Enter the sample rate in seconds.
5. Enter the overload trigger number.
6. Enter the overload window size.
7. Enter the overload percentage utilization.
8. Enter the underload trigger number.
9. Enter the underload window size.
10. Enter the idle trigger number.
11. Enter the idle window size.
12. Enter the idle percentage utilization.
13. Press "Y" to accept the configuration changes you have made.
U
SING MANAGE MODE COMMANDS
thruput
Displays the current throughput monitor configuration data.
thruput change
Allows the current throughput monitor configuration data to be changed. Refer to the
CFGEDIT section for specific parameters.
THROUGHPUT MONITOR CONFIGURATION ELEMENTS
SAMPLE RATE
A Sample Rate identifies the number of seconds for each sample period. The default setting for the
sample rate is 5 seconds. During this period, the system keeps track of the total number of bytes
that is transferred in both directions between two systems. The utilization percentage is determined
by comparing this total with the realistic maximum for the current aggregate amount of
bandwidth.
O
VERLOAD TRIGGER NUMBER
The number of samples within the window that must exceed the specified utilization for the
OVERLOAD condition to occur.
O
VERLOAD WINDOW SIZE
The number of sample periods (up to 32) that you should use as the sliding window.
O
VERLOAD PERCENT UTILIZATION
The percentage of the available bandwidth that the traffic samples must exceed for an overload
condition to occur.