Filter
Top Products
Workgroup Remote Access Switch 515
S
YSTEM
C
OMMANDS
Accessing Dynamic Management
autobaud
This command notifies the boot device to check the baud rate. It prepares the boot device to
recognize an imminent change. At this time, you should be prepared to set or change the baud
rate in your communications package.
update
This command notifies the boot device that you are attempting a new upgrade. It is preparing
the SSB for download of software via the XMODEM.
recover
This command notifies the boot device that you are attempting a download of the Second Stage
Boot software.
<CR>
Press Enter (Carriage Return) to skip the 10-second delay between the first and second stage
boot.
For specific situations of command usage, refer to Upgrading System Software.
ACCESSING DYNAMIC MANAGEMENT
The Dynamic Management feature provides a “real-time” management mechanism that allows
changes to system parameters without interrupting the current execution state of the system
software. This feature consists of a series of console commands that allow you to display current
system parameters, change many parameters dynamically, and write changes to disk files so that
they remain permanent.
All dynamic management commands must be issued through a special mode of operation called
Manage Mode. To enter Manage Mode, type the following command at the system prompt:
>manage
Once Manage Mode is entered, the prompt changes from
“>”
to “MANAGE>“.While operating
in Manage Mode, Manage Mode commands are the only commands available. All other system
commands are ignored until you enter the
exit
command to return to normal system command
mode.
VIEWING OPERATIONAL INFORMATION
The following commands are used to view system operational information:
?
Displays a help screen outlining all of the commands that are available.
br stats
Displays the current system packet statistics. Refer to Bridge Statistics, for a list of available
statistics and their definitions.
cls
Clears the administration screen.