Filter
Top Products
USER’S GUIDE
300 CyberSWITCH
USING MANAGE MODE COMMANDS
Currently you cannot configure SNMP using the Manage Mode, but the following command is
available:
snmp
This Manage Mode command displays the current SNMP configuration data. An example
output screen is shown below:
SNMP CONFIGURATION ELEMENTS
SNMP STATUS
You may enable or disable the SNMP feature.
C
OMMUNITY NAME
A 1 to 20 character case-sensitive string that specifies a Community Name that will be accepted by
the SNMP Agent if it is specified in an incoming Request PDU.
MIB A
CCESS LEVEL
The MIB Access Level associated with a Community Name must be selected from the supplied list.
It dictates the level of access available to the associated Community Name. The following is a chart
of the three possible access levels and their access privileges.
MANAGE> SNMP
The SNMP feature is enabled.
Current SNMP COMMUNITY NAME Configuration:
id MIB ACCESS LEVEL COMMUNITY NAME
--- -------------------------------------------
1 MIB_ADMIN public
2 MIB_USER user
3 MIB_ADMIN test
Current SNMP TRAP RECEIVER List Configuration:
id IP ADDRESS COMMUNITY NAME
----------------------------------------------
1 128.111.001.001 public
2 144.123.111.099 public
3 102.003.003.222 test
The generation of Authentication Failure Traps is disabled.
The generation of ISDN B-Channel Usage Traps is enabled.
The ISDN B-Channel Usage Trap threshold is 5 B-Channels.
Access Level Access Privileges
MIB GUEST get (read) MIB-2 system group only
MIB USER get (read) all MIB-2 and Enterprise MIB objects
MIB ADMIN get (read) all MIB objects and set (write) all MIB objects
that are writable