Filter
Top Products
Workgroup Remote Access Switch 361
S
YSTEM
V
ERIFICATION
Verifying IP Routing Over Interfaces
To verify IP Routing over a LAN connection:
1. Determine if the CyberSWITCH can access the local IP host. On the administration console
type:
ip ping 100.0.0.2
<return>
Issuing this command will result in a response similar to the following:
100.000.000.002 is alive
If the system displays this message, then IP routing over that LAN port is operational. Repeat
this step for each LAN port on your Ethernet resource.
If this message IS NOT displayed, then IP routing over the LAN connection is not operational.
Refer to IP Routing Over the LAN Connection in the Problem Diagnosis chapter.
2. Once IP routing is operational on each LAN port on your Ethernet resource, then IP routing
over the LAN Connection is operational.
VERIFYING IP ROUTING OVER A WAN INTERFACE
To verify that IP routing is properly operational over a WAN interface, a remote IP Host must be
operational and available to initiate connections. Also, a local IP host must be connected to the local
LAN port of the CyberSWITCH.
Below is an example of a configuration used to verify IP routing over a WAN interface. It uses IP
addresses specific to the example. Substitute the IP addresses of your network when you perform
the verification steps. It also uses the “ping” command. The “ping” command sends a packet to a
specified host, waits for a response, and reports success or failure. Substitute the equivalent
command on your IP host.
Host A
100.0.0.1
100.0.0.0
100.0.0.2
WORKGROUP REMOTE ACCESS SWITCH
LAN
10BASE-TRXTXSERVICE
CH-2
D-CH
CH-1
SYNC
POWER
LINE
1
CH-2
D-CH
CH-1
SYNC
LINE
2
CH-2
D-CH
CH-1
SYNC
LINE
3
CH-2
D-CH
AGI
CH-1
SYNC
LINE
4
CSX1200