Cabletron Systems CSX1200 Switch User Manual


 
USER’S GUIDE
360 CyberSWITCH
2. If a message similar to the following is displayed, the IP host mode feature over the specified
LAN port is operational. Repeat this step for each LAN port on your Ethernet resource.
100.0.0.2 is alive
3. If this message is not displayed, then the IP Host mode feature over the LAN connection is not
operational. Refer to IP Host Mode Operation over the LAN Interface Connection in the Problem
Diagnosis chapter.
4. Once IP Host Mode feature is operational on each LAN port on your Ethernet resource, then IP
Host Mode feature over the LAN Connection is operational.
V
ERIFYING IP HOST MODE OPERATION OVER A WAN CONNECTION
The steps to verify the operation of IP Host mode feature over a WAN connection are:
1. Determine if a remote IP Host (Host B) can access the system. On the remote IP host type:
ping 100.0.0.1
2. If a message similar to the following is displayed, the IP host mode feature over the specified
WAN connection is operational.
100.0.0.1 is alive
3. If this message is not displayed, then IP Host mode feature over the WAN connection is not
operational. Refer to IP Host Mode Operation over the WAN Connection in the Problem Diagnosis
chapter.
VERIFYING IP ROUTING OVER INTERFACES
The following sections provide a method of verifying that IP routing is operational over the
available interfaces.
VERIFYING IP ROUTING OVER A LAN INTERFACE
To verify that IP routing is operating properly over the LAN connection, an IP host must be
connected to the local LAN port on the CyberSWITCH. The host must be properly configured and
operational on the IP network to which it is connected.
Below is an example of a configuration used to verify IP routing over a LAN connection. It uses IP
addresses specific to the example. Substitute the IP addresses of your network when you perform
the IP routing verification steps.