Cabletron Systems CSX1200 Switch User Manual


 
Workgroup Remote Access Switch 185
C
ONFIGURING
O
FF
-
NODE
S
ERVER
I
NFORMATION
ACE Authentication Server
system will send an access request retry if the primary server does not respond. After the
configured number of retries, the system will request authentication information from the
secondary server if one is configured. The connection will be released if neither server responds to
the access requests.
Note: For user level security, the CyberSWITCH’s default Telnet port number is 7000, not the
normal default (23).
ACE AUTHENTICATION SERVER
CONFIGURING AN ACE AUTHENTICATION SERVER
Note: In order for the CyberSWITCH to reference ACE server, the following configuration steps
must first be completed:
basic IP routing information must be configured for ACE
a LAN Network interface must be configured appropriately for the IP network
connected to each LAN port on the system
at least one WAN Network Interface must be configured for ACE to be operable
U
SING CFGEDIT
1. Select option (4), ACE from the Off-node Server Information menu. If you need guidance to
find this menu, refer to the instructions provided in the VRA Manager Authentication Server
configuration section. The following screen will be displayed:
2. Select Primary Server and enter the following information:
a. IP address of the Authentication Server
b. UDP port number used by the Authentication Server
3. If your configuration includes an ACE Slave server, then select Secondary Server. Enter its IP
address. The UDP port number for the Master and Slave servers will be the same, regardless of
which server configuration screen from which it is entered.
ACE Authentication Server Menu:
Primary (Master) Server
is Not Configured
Secondary (Slave) Server
is Not Configured
Access Request
Number of Access Retries is 3
Time between Retries is 1 second
Encryption Method SDI
Source IP address is Not Configured
ACE Server Options:
1) Primary (Master) Server
2) Secondary (Slave) Server
3) Miscellaneous Information
4) Load ACE configuration file.
Select function from above or <RET> for previous menu:
1