Cabletron Systems CSX1200 Switch User Manual


 
Workgroup Remote Access Switch 369
S
YSTEM
V
ERIFICATION
Verifying IP RIP
perform the verification steps. It also uses the
show ip route
command. The
show ip route
command is used by a specific router to display the IP routing table. Substitute the equivalent
command for your IP router.
The steps to verify the operation of IP RIP output processing on a WAN interface are:
1. Make sure that a dedicated connection between system and Router is up and operational. On
the system’s administration console:
Type:
cs
<return>
If the connection to Router is displayed, the continue with the next step.
2. Determine if Router has learned the route to 192.1.1.0 from the system. On the Router:
Type:
show ip route
<return>
If the route to 192.1.1.0 is displayed, the IP RIP output processing is operational.
If the route is NOT displayed, refer to IP RIP Output Processing on a WAN Interface in the Problem
Diagnosis chapter.
VERIFY IP RIP INPUT PROCESSING OPERATIONAL ON A WAN INTERFACE
To verify that IP RIP Input Processing (routes learning) is properly operational on a WAN interface,
the IP RIP processing must be successfully initialized.
The same example that is used in the previous section is used to verify IP RIP input processing on
a WAN interface.
To verify the operation of IP RIP Input processing on a WAN interface:
1. Make sure that a dedicated connection between system and Router is up and operational. On
the CyberSWITCH administration console:
Type:
cs
<return>
If the connection to Router is displayed, the continue with the next step.
2. Determine if system has learned the route to 192.1.2.0 from the Router. On the CyberSWITCH
administration console:
Type:
ip route
<return>
If the route to 192.1.2.0 is displayed, the IP RIP input processing is operational.
If the route is NOT displayed, refer to IP RIP Input Processing on a WAN Interface in the Problem
Diagnosis chapter.
Dedicated Connection
Router
192.1.1.1
100.1.1.1
100.1.1.2
192.1.2.1
CSX1200
WORKGROUP REMOTE ACCESS SWITCH
LAN
10BASE-TRXTXSERVICE
CH-2
D-CH
CH-1
SYNC
POWER
LINE
1
CH-2
D-CH
CH-1
SYNC
LINE
2
CH-2
D-CH
CH-1
SYNC
LINE
3
CH-2
D-CH
AGI
CH-1
SYNC
LINE
4