Filter
Top Products
USER’S GUIDE
242 CyberSWITCH
Upon selecting IP Filter Information, the following sub-menu is displayed:
The configuration of each of the listed functions is described in the following discussion.
U
SING MANAGE MODE
ipfilt
This command displays the IP Filter Configuration screen from which you can set up your
packet types and filters.
Note: Since IP Network Interfaces are not currently changeable within Manage Mode, the
application of filters to Interfaces may only be performed within CFGEDIT.
CONFIGURING PACKET TYPES
USING CFGEDIT
1. Select Packet Types from the IP Filter menu.
2. Select Add.
3. Assign a unique name to the packet type. The system will then display the new packet with
wild card values, similar to the following:
IP Routing Menu:
1) IP Routing (Enable/Disable)
2) IP Operating Mode
3) IP Interfaces
4) IP Static Routes
5) RIP (Enable/Disable)
6) IP Static ARP Table Entries
7) Isolated Mode(Enable/Disable)
8) Static Route Lookup via RADIUS(Enable/Disable)
9) IP Address Pool
10) DHCP Configuration
11) IP Filter Information.
Select function from above or <RET> for previous menu:
11
IP Filters:
1) Packet Types
2) Forwarding Filters
3) Connection Filter
4) Exception Filter
5) Apply Global Forwarding Filter.
Select function from above or <RET> for previous menu:
Current Configuration for PACKET TYPE "Type_One"
1) IP Source Address AND 0.0.0.0 EQUAL 0.0.0.0
2) IP Destination Address AND 0.0.0.0 EQUAL 0.0.0.0
3) IP Protocol EQ ANY
Select function from above or <RET> for previous menu: