Filter
Top Products
Workgroup Remote Access Switch 551
S
YSTEM
C
OMMANDS
SNMP Commands
SNMP COMMANDS
When the SNMP Agent is enabled on the CyberSWITCH, the following command is available:
snmp stats
Displays the current SNMP related statistics. Refer to SNMP Statistics, for a list of available
statistics and their definitions.
TCP COMMANDS
TCP (Transmit Control Protocol) provides a connection-oriented reliable communication for
delivery of packets to a remote or on-node device. When the IP feature is enabled, the following
TCP commands are available:
tcp conns
Display the current TCP connection status with the following format:
lport
The local port number for this TCP connection.
fhost
The remote IP address for this TCP connection.
fport
The remote port number for this TCP connection.
window (l/r)
The current receive windows for the local and remote ends of this TCP connection.
tstate
The current state of this TCP connection.
outq (s/u)
The number of bytes that has been sent but not acknowledged yet and the number of bytes in
the output queue that has not been sent on this TCP connection.
tcp stats
Displays the current system TCP related statistics. Refer to TCP Statistics, for a list of available
statistics and their definitions.
TELNET COMMANDS
These commands are Telnet client console commands. These commands provide tools for you
when you are using the system as a Telnet client. As a Telnet client, the CyberSWITCH can then be
used to Telnet into another CyberSWITCH to perform system maintenance, for example, updating
configuration information. These commands are not needed for a Telnet session as a rule, but may
be beneficial for some users. For more information regarding the system’s Telnet client feature,
refer to the Telnet section of the Remote System Management chapter.