Filter
Top Products
USER’S GUIDE
486 CyberSWITCH
X25 facilities warning, NUI not available
Network device identification not available. No action required.
X25 permanent virtual circuit down: Access=<access index>, PVC=<PVC index>, LCN=<LCN>
The indicated X.25 virtual circuit is down. Switched backup connections will be used, if available.
This message will occur if the other system is down, or if the network interface line is not connected,
or if the authentication of the remote device failed.
X25 permanent virtual circuit to device <device name> up: Access=<access index>, PVC=<PVC index>,
LCN=<LCN>
The indicated X.25 virtual circuit is operational.
XMODEM DATA FAILED CRC CHECKS
A file contained in the X-Modem file set has failed the CRC check. The system will automatically
reset and attempt a reboot in an effort to correct the problem. If the system continues to fail, make
note of the displayed messages, and call your distributor. A software update is likely needed.
Zone allocation failed, increase zone table capacity.
The number of AppleTalk zones has surpassed the configured zone table capacity. The
CyberSWITCH configuration utility allows you to set the maximum number of defined and
learned zone table entries. The default value is 512. The maximum is 2,000. You may need to reset
the zone table capacity to a higher number.
Zone allocation failed, maximum capacity already configured
The maximum number of AppleTalk zones have been surpassed. Contact your Distributor or
Customer Support.