Filter
Top Products
USER’S GUIDE
546 CyberSWITCH
pkt capture [all/idle/reqd/pend/actv/none]
Specifies which packets will be captured by the Packet Capture feature. A definition of each
possible parameter follows.
all
All packets will be captured.
none
No packets will be captured.
reqd
Only packets causing a connection to be requested will be captured.
pend
Only packets received while a requested connection is pending will be captured.
idle
Only packets not causing a connection to be requested will be captured. This could be
caused by the destination site not being in the Initiate Connection List, or by the route not
being in the IP Routing Table.
The
pkt capture
command allows multiple connection modes to be specified on a single
command line. For example, the command:
pkt capture reqd pend
captures only packets that cause a connection to be requested and packets that were received
before the connection became active.
pkt load <filename>
Loads previously saved Packet Capture file into memory.
pkt save <filename>
Saves captured packets to a disk file. Full path names are allowed, for example:
A:MYPKT.DAT.
pkt display
Displays captured packets that have been collected via
pkt on
or via
pkt load
. Note that this
command is not supported for a Telnet session.