Filter
Top Products
30-26
Cisco ASA Series Firewall ASDM Configuration Guide
Chapter 30 Configuring the ASA CX Module
Managing the ASA CX Module
(ASA 5512-X through ASA 5555-X) Uninstalling a Software Module Image
To uninstall a software module image and associated configuration, perform the following steps.
Guidelines
In multiple context mode, perform this procedure in the system execution space.
Detailed Steps
(ASA 5512-X through ASA 5555-X) Sessioning to the Module From the ASA
To access the ASA CX software module CLI from the ASA, you can session from the ASA. You can
either session to the module (using Telnet) or create a virtual console session. A console session might
be useful if the control plane is down and you cannot establish a Telnet session.
You may need to access the CLI if you are using multiple context mode and you need to set basic network
settings using the CLI, or for troubleshooting.
Guidelines
In multiple context mode, perform this procedure in the system execution space.
Command Purpose
Step 1
sw-module module cxsc uninstall
Example:
ciscoasa# sw-module module cxsc uninstall
Module cxsc will be uninstalled. This will
completely remove the
disk image associated with the sw-module
including any configuration
that existed within it.
Uninstall module <id>? [confirm]
Permanently uninstalls the software module image and associated
configuration.
Step 2
reload
Example:
ciscoasa# reload
Reloads the ASA. You must reload the ASA before you can install
a new module type.